Answers about IMER machines and parts

6 answers

• The paddles in my Mix 750 scrape or hit the drum. What clearance should the wiper rubbers have?

  Stop the mixer and cut all power. IMER gives the paddle wiper rubbers a spacing of about 5 mm (roughly 0.2 in) from the drum, and as the rubbers wear that gap has to be…

  Troubleshooting · IMER Mix 750

• What maintenance does a Mix 750 need, and what gearbox oil does it take?

  Wash the mixer thoroughly after each use and spray off the area beneath the discharge gate a few times a day. Change the gearbox oil once after the first 50 hours, then…

  Maintenance · IMER Mix 750

• How do I start the gas engine on a Mix 750, and how long can I crank it?

  On key-start gas models, turn the key clockwise from 0 to the first click (position 1) and keep it there. If the engine does not catch, try again, but crank for no more…

  Operation and setup · IMER Mix 750

• Can I restart a Mix 750 with mortar still in the drum?

  Yes, within limits. The manual allows a restart with the drum up to three-quarters full. If it was full when it stopped, take some material out first. Do not let mortar…

  Operation and setup · IMER Mix 750

• What tire pressure and checks do I need before towing a Workman II 250 or a Mix 750?

  The Workman II 250 manual says to inflate each tire to 50 PSI cold, and the Mix 750 manual says 40 PSI. Both manuals add these checks. Raise the stability legs fully…

  Operation and setup · IMER Workman 250 · IMER Mix 750

• What motor options does the Mix 750 come with?

  Per IMER's product sheet the Mix 750 comes as a 240 V, 5 hp single-phase electric (1194644); a 208 V, 7.5 hp three-phase (1194645); a 480 V, 7.5 hp three-phase…

  Specs and selection · IMER Mix 750