Answers about IMER machines and parts

4 answers

• What size diamond disc does the Masonry 750 Plus take, and how do I change it?

  The Masonry 750 Plus uses a disc with a 750 mm (30 in) outside diameter, a 25.4 mm center hole and a maximum thickness of 4 mm. A 700 mm disc can also be fitted, but…

  Specs and selection · IMER Masonry 750 Plus

• How much water does the Masonry 750 Plus need, and what can it cut?

  Fill the tank so it holds at least 60 and at most 90 litres (about 16 to 24 gal); the water pump must stay submerged, so top it up as the level drops. Cutting must…

  Operation and setup · IMER Masonry 750 Plus

• How is the drive belt tension set on the Masonry 750 Plus?

  IMER specifies checking belt tension with a frequency (vibration) meter. For 400 V motors at 50 or 60 Hz, the reference is 47 Hz when new and 45 Hz once run in; for 220…

  Maintenance · IMER Masonry 750 Plus

• Which IMER diamond blade type should I use for tile, brick or concrete?

  IMER's blade page sorts its blades by job. Continuous-rim blades suit ceramic tile, porcelain and stone and give the cleanest, most accurate cut: 8 in (1193920), 10 in…

  Specs and selection · IMER Combicut 350 iPower · IMER Masonry 750 Plus