Troubleshooting
IMER Syntesi 190 EL problems and fixes
The troubleshooting table of the IMER manual 3228768 R12, problem by problem: the likely causes, what the manual says to do and the parts for each fix.
- problems
- 3
Disconnect the machine from power before any check. Fixes marked Qualified person involve electrical, pressure or engine work: have them done by a qualified technician and follow the safety instructions in your IMER manual.
Motor does not start when switch is turned
Possible cause What to do Defective power cable Check power cables * Plug not inserted in socket correctly Ensure correct connection Power cable from plug to control panel detached Remake the connection * Loose wire inside motor circuit board Remake the connection * A wire has become disconnected inside the panel Remake the connection * Faulty main switch Replace switch The overload safety device has been activated Wait for a few minutes and then try restarting the machine Qualified person: this fix involves electrical, pressure or engine work.
Source: IMER manual 3228768 R12, page 14
When unloading, the handle will turn by itself
Possible cause What to do Tipping brake worn Replace the brake Source: IMER manual 3228768 R12, page 14
During mixing the mixer drum rpm decreases
Possible cause What to do Belts are worn or slack Tension or replace the belts Parts named in these fixes, from the Syntesi 190 EL parts book
- Belt for IMER Mixers3208791 · drawing 1/A, ref 18$41.00
Check the part number on your machine or in its parts book before you order.
Source: IMER manual 3228768 R12, page 14