Troubleshooting
IMER Mix 60 Plus problems and fixes
The troubleshooting table of the IMER manual, problem by problem: the likely causes, what the manual says to do and the parts for each fix.
- problems
- 3
Disconnect the machine from power before any check. Fixes marked Qualified person involve electrical, pressure or engine work: have them done by a qualified technician and follow the safety instructions in your IMER manual.
The motor does not start when switched on
Possible cause What to do No power on power cable Check power cables Plug not inserted correctly in socket Ensure correct connection Faulty power cable to electrical panel Change power cable Loose wire in electrical panel Reconnect wire Loose wire in motor terminal board Reconnect wire Faulty main switch Replace switch Residual current circuit breaker tripped Reset switch. If it does not reset, refer to a qualified electrician to check the electrical system to ensure complete safety. Qualified person: this fix involves electrical, pressure or engine work.
Source: IMER manual, page 6
The motor does not stop when the safety grid is lifted
Possible cause What to do Faulty limit switch Replace limit switch Qualified person: this fix involves electrical, pressure or engine work.
Parts named in these fixes, from the Mix 60 Plus parts book
- Limit Switch for IMER Mix 60 Plus3200005 · drawing 1, ref 21$110.00
Check the part number on your machine or in its parts book before you order.
Source: IMER manual, page 6
Motor starts with difficulty
Possible cause What to do Mixture is too stiff Reduce mixture quantity or dilute and try again. Source: IMER manual, page 6