Skip to content
IMER PartsUSA

Any format works

Type the number from your parts book, the way it is printed, or a machine name.

  • 3237223
  • 3237-223
  • IMER 3237 223
  • Mix 750

Browse by machine

IMER PartsUSA
Call +1 (307) 301-7723

Mon–Fri 8 am–6 pm, Sat 9 am–1 pm (Mountain Time)

Troubleshooting

IMER Masonry 750 Plus problems and fixes

The troubleshooting table of the IMER manual 3236275 R02, problem by problem: the likely causes, what the manual says to do and the parts for each fix.

problems
5
Disconnect the machine from power before any check. Fixes marked Qualified person involve electrical, pressure or engine work: have them done by a qualified technician and follow the safety instructions in your IMER manual.
  1. Motor fails to start when switch is operated
    Possible causeWhat to do
    Voltage not reaching supply lineCheck the line *
    Electrical socket and plug are not properly connectedRestore correct connection
    The power cable from the plug to the panel is cut offChange the cable *
    An electrical wire in the motor terminal board is disconnectedRestore the connection *
    An electrical wire in the electrical panel is disconnectedRestore the connection *
    The ON switch is faultyReplace the switch *
    A fuse has blownReplace the fuse *
    The thermal safety device has been triggeredWait a few minutes and try again

    Qualified person: this fix involves electrical, pressure or engine work.

    Source: IMER manual 3236275 R02, pages 7–8

  2. Difficult trolley horizontal sliding
    Possible causeWhat to do
    Dirty runnersClean the runners

    Source: IMER manual 3236275 R02, page 8

  3. No cooling water reaching disc
    Possible causeWhat to do
    -Refer to "cleaning and maintenance of the cooling system" (par. 17.5)

    Source: IMER manual 3236275 R02, page 8

  4. Disc fails to cut
    Possible causeWhat to do
    The disc is wornReplace with new disc
    Transmission belt not tensionedTighten the belts

    Parts named in these fixes, from the Masonry 750 Plus parts book

    Check the part number on your machine or in its parts book before you order.

    Source: IMER manual 3236275 R02, page 8

  5. Motor starts but disc does not turn
    Possible causeWhat to do
    Belt brokenReplacing the drive belt

    Parts named in these fixes, from the Masonry 750 Plus parts book

    Check the part number on your machine or in its parts book before you order.

    Source: IMER manual 3236275 R02, page 8

IMER Masonry 750 Plus partsAsk a parts specialist