Answers about IMER machines and parts

8 answers

• What tire pressure and checks do I need before towing a Workman II 250 or a Mix 750?

  The Workman II 250 manual says to inflate each tire to 50 PSI cold, and the Mix 750 manual says 40 PSI. Both manuals add these checks. Raise the stability legs fully…

  Operation and setup · IMER Workman 250 · IMER Mix 750

• How tight should the belts on a Workman II 250 be, and how do I adjust them?

  The Workman II 250 uses two belts, one inside the canopy and one in the arm, and each should deflect 1/4 to 3/8 in. First stop the engine and pull the spark plug wire…

  Maintenance · IMER Workman 250 · IMER Workman II 250

• Which belt part numbers are listed for the Workman II 250?

  The IMER parts book for the Workman II 250 lists three belt entries on the main mixer drawing (1.3): a motor belt, 2210950 (ref 14); a belt 530 J6, 3209049 (ref 47)…

  Parts and fitment · IMER Workman 250

• What routine maintenance does a Workman II 250 need?

  From the manual: look at the engine oil every day and change it every month, and clean the air filter once a week. Once a week, spray the moving parts with a light…

  Maintenance · IMER Workman 250 · IMER Workman II 250

• Does the Workman gearbox need oil changes, and which oil seals does it use?

  IMER describes the Workman gearbox as sealed for life, so no routine oil change is needed. If you still want to change the oil, the manual says to see your dealer or…

  Maintenance · IMER Workman 250

• What torque do I use when refitting the drum on a Workman II 250 or 350?

  Clean both the cone on the gear shaft and the cone inside the drum. Seat the drum on the shaft cone so the shaft shear pin falls into its slot in the drum cone. Then…

  Maintenance · IMER Workman 250 · IMER Workman II 350

• Which machines use the 35x20x7 gearbox oil seal, part 3200094?

  The IMER parts books list oil seal 3200094, size 35x20x7, in several gearbox drawings: the Workman II 250 gearbox (drawing 2, ref 13), the Mix 120 Plus gearbox (drawing…

  Parts and fitment · IMER Workman 250 · IMER Mortarman 120 Plus

• Are belts, blades, hoses and filters covered by the machine warranty?

  No. The warranty page in the Workman II 250 manual leaves out maintenance items such as blades, belts, hoses, hydraulic oil and filters. It also does not apply to…

  Ordering, shipping and warranty · IMER Workman 250