Answers about IMER machines and parts

4 answers in Maintenance

• How tight should the belts on a Workman II 250 be, and how do I adjust them?

  The Workman II 250 uses two belts, one inside the canopy and one in the arm, and each should deflect 1/4 to 3/8 in. First stop the engine and pull the spark plug wire…

  Maintenance · IMER Workman 250 · IMER Workman II 250

• What routine maintenance does a Workman II 250 need?

  From the manual: look at the engine oil every day and change it every month, and clean the air filter once a week. Once a week, spray the moving parts with a light…

  Maintenance · IMER Workman 250 · IMER Workman II 250

• Does the Workman gearbox need oil changes, and which oil seals does it use?

  IMER describes the Workman gearbox as sealed for life, so no routine oil change is needed. If you still want to change the oil, the manual says to see your dealer or…

  Maintenance · IMER Workman 250

• What torque do I use when refitting the drum on a Workman II 250 or 350?

  Clean both the cone on the gear shaft and the cone inside the drum. Seat the drum on the shaft cone so the shaft shear pin falls into its slot in the drum cone. Then…

  Maintenance · IMER Workman 250 · IMER Workman II 350